Adam's Dirt Lock fits securely in the bottom of your wash bucket and is powered purely by the force of your hand on the wash pad. The jet turbine design speeds up debris removal and creates a Venturi effect to extract the dirt from the washing accessory. Since the gaps and channels around the Dirt Lock are tapered from top to bottom, this allows the mass of grime, dirt, and debris to be pulled underneath and not reintroduced to the clean water. Once installed in the bucket, the foam pads on the outer fins of the Dirt Lock effectively hold the apparatus in place. The flexible rubber tabs allow for the perfect fit in almost any bucket application, whether 3, 3.5, 5, 6, 7 or 8 gallon round buckets! This chemical and crush resistant design is certain to be your new favorite detailing essential. Each time you put your hand into the bucket you are cycling dirt down through the screen and replenishing it with cleaner, reusable water for your washing.
The other products on the market have not grasped the concept of utilizing fluid dynamics to make the bucket insert act as a pump. The patented Dirt Lock design utilizes the motion of your hand to filter nearly 100% of your wash water. Each time you pulse your hand, the water is dramatically sped up by the shape of the turbine and through hundreds of tapered Venturi funnels. The compression of the water and debris passing through the turbine & Venturi funnels will blast dirt to the bottom of the bucket, with only fresh, clean water returning along the side of the dirt-lock through the fresh water troughs.
*NOTE Foam Cannons do not operate on Pressure Washers that have Flow-Sensing unloaders. Typically, you will have pulsing foam indicating pressure spikes and drops which the flow-sensing unloaders cannot accommodate.
*NOTE A specific 1/4" Male plug may be required in order to attach the QC plug to the end of some residential pressure washer setups. MTM Hydro 1/4" plugs are standard for industrial use but many residential pressure washers such as Generac, Greenworks, Ryobi, AR Blue Clean, etc... have certain models where the coupler will not receive an MTM plug. Not all of these brands are impacted, just certain models. If you look closely, the Chamfer at the end of an MTM plug as well as the neck is, 1.5mm shorter than some couplers may allow. Once you install the correct plugin your new MTM Foam Cannon, you sill see that it was worth finding this specialized fitting as our foam cannons are second to none, even when manufacturers try to change their fittings!